0
Owner's of the Whirlpool Washer/Dryer LDR3822PQ gave it a score of 0 out of 5. Here's how the scores stacked up:
8
Install Cord Bracket and Casters
Do not move dryer into its final position until the following steps
have been performed.
Install cord bracket
1. Remove tape from the power cord and the rear panel.
2. Insert cord brackets into slotted holes in rear panel and
secure with screws provided.
NOTE: Power supply cord may be wrapped around the bracket s
for storage convenience when dryer is not in use.
Install casters
1. Lay the dryer on its side.
2. Use the carton to prevent damage to the dryer.
3. Screwcas ters into dryer base at four corners and tighten
securely.
4. Set the dryer upright. In doing so, be careful that the dryer
does not roll away from you.
NOTE: Permanent installations require 4 dryer feet. See
“Assistance or Service” section for ordering information.
Connect Vent
1. Using a 4" (102 mm) clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sure the vent is
clean. The dryer vent must fit over the dryer exhaust outlet
and inside the exhaust hood. Make sure the vent is secured
to exhaust hood with a 4" (102 mm) clamp.
2. Move dryer into final position. Do not crush or kin k vent.
Make sure dryer is level.
3. (On gas models) Checkt o be sure there are no kinksin
the
flexible gas line.
Complete Installation
1. Check to be sure all parts are now installed. If there is an
extra part, go back through the steps to see wh ich step was
skipped.
2. Check to be sure you have all of your tools.
3. Dispose of/r ecycle all packaging materials.
4. Check the dryer’s final location. Be sure the vent is not
crushed or kinked.
5. Check to be sure the dryer is on a level surface.
6. Plug into a grounded 3 prong outlet. Turn power on.
7. Remove the blue protective film on the console and any tape
remaining on the dryer. Remove tape from the lint screen
(located on inside back wa ll of dryer).
8. Read “Dryer Use.”
9. Wipe the dryer drum interior thoroughly wi th a damp cloth to
remove any dust.
10. To test the dryer, set the dryer on a full heat cycle (not an air
cycle) for 20 minutes and start the dryer.
If the dryer will not start, check the following:
Controls are set in a running or “On” position.
Start button has been firmly pushed.
Dryer is plugged into a grounded 3 prong outlet.
Electrical supply is connected.
House fuse is intact and tight, or circuit breaker has not
tripped.
Dryer door is closed.
11. When the dryer has been running for 5 minutes, open the
dryer door and feel for heat.
If you do not feel heat, check the following:
Controls are set on a heated cycle, not an air cycle.
NOTE: You may notice an odor when dryer is first heated.
This odor is common when the heating element is first used.
The odor willgoaway.
A. Cord bracket
B. Slotted hole
C. Screw
WARNING
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
B
A
C
Find Your Products By Category
Please Login
